Removing & Fitting General Electrical Components
- Place a drop sheet or old towels around the recliner.
- Turn off and remove the power supply plug from the mains.
- Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
- Locate the component and its lead. Follow the lead along to the plug end remembering where it runs.
- Using a pair of side cutters, snip the cable ties that are retaining the lead to the frame.
- Unplug the socket and remove the old component. Place the new component lead along the same path as the old and cable tie the new lead to the frame.
- Check all other leads are out of the way of moving parts.
- Turn the recliner back over to normal seating position
- Plug the main power supply back into the wall.
- Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
- Return the lift chair to its normal seating position.
Tip: Check that all the leads are cable tied away from moving parts before turning the power supply back on. Leads can sometimes get jammed between moving parts causing a dead short after the chair is moved.
DO NOT exceed more then 2 mins operating time at anyone time. If you do exceed this time, wait 20 mins before using again.