Couch Guard Aus | SKU: OKIN-SP2-B

Okin SP2-B Power Supply

$61⁹⁰

Select Your Option

Product variants

Okin SP2-B Power Supply

Genuine Okin SP2-B power supply is compatible with the Kaidi KDDYOO1B power supply. This lift chair recliner power supply can also be used on the electric recliner chairs, has a two pins - the "O l" flat blade / round pin plug and takes the figure 8 power cord as standard and has provisions for 2 x 9volt batteries - not included. ALL of our electrical items are "C" Tick Approved and Meet Australian Standards. The SP2-B and the SP2-B1 are all the same specifications. Buy Genuine Okin Parts From CouchGuard®

Description

Okin SP2-B Power Supply has an input voltage is 100-240VAC 50/60HZ and the output is 29v DC 2.0 amp and the two pin plug is the industry standard and fit 99.9% of the recliners on the market. The 9v battery back up option is generally good for one use only then the batteries need replacing.

Directions

Removing & Fitting General Electrical Components

Place a drop sheet or old towels around the recliner.
Turn off and remove the power supply plug from the mains.
Gently turn the recliner over onto its side or on its back. Remember correct lifting methods.
Locate the component and its lead. Follow the lead along to the plug end remembering where it runs.
Using a pair of side cutters, snip the cable ties that are retaining the lead to the frame.
Unplug the socket and remove the old component. Place the new component lead along the same path as the old and cable tie the new lead to the frame.
Check all other leads are out of the way of moving parts.
Turn the recliner back over to normal seating position
Plug the main power supply back into the wall.
Test the new component. Operate the lift chair recliner to its fullest position and check that all the leads are clear and not stretched.
Return the lift chair to its normal seating position.

Tip: Check that all the leads are cable tied away from moving parts before turning the power supply back on. Leads can sometimes get jammed between moving parts causing a dead short after the chair is moved.

DO NOT exceed more then 2 mins operating time at anyone time. If you do exceed this time, wait 20 mins before using again.